A cathode ray tube or CRT, is traditionally used in most computer monitors and the advent of plasma screens, LCD , DLP, OLED displays, and other technologies. As a result of CRT technology, computer monitors continue to be referred to as "The Tube".A CRT works by moving an electron beam back and forth across the back of the screen. Each time the beam makes a pass across the screen, it lights up phosphor dots on the inside of the glass tube, thereby illuminating the active portions of the screen. By drawing many such lines from the top to the bottom of the screen, it creates an entire screenful of images.

A Liquid crystal display (LCD) is a thin, flat display device made up of any number of color or monochrome pixels arrayed in front of a light source or reflector. It uses very small amounts of electric power, and is therefore suitable for use in battery-powered electronic devices.

A plasma display is an emissive flat panel display where light is created by phosphors excited by a plasma discharge between two flat panels of glass. The gas discharge contains no mercury a mixture of noble gases (neon and xenon) is used instead. This gas mixture is inert and entirely harmless.

The glass panels seem to be vacuum sealed, because when they are broken the plasma breaks up, seemingly from the addition of air to the space.

Surface-conduction electron-emitter display (SED) is a flat-panel, high-resolution display. Some SEDs have a diagonal measurement exceeding one meter (approximately 40 inches). The SED consists of an array of electron emitters and a layer of phosphor, separated by a small space from which all the air has been evacuated. Each electron emitter represents one pixel. The SED requires no electron-beam focusing, and operates at a much lower voltage than a CRT. The brightness and contrast compare favorably with high-end CRTs. Prototype electron emitters have been developed with diameters of a few nanometers. SED technology can offer unprecedented image resolution.

Digital Light Processing (DLP) is a technology used in projectors and video projectors. In DLP projectors, the image is created by microscopically small mirrors laid out in a matrix on a semiconductor chip, known as a Digital Micromirror Device (DMD). Each mirror represents one pixel in the projected image. The number of mirrors corresponds to the resolution of the projected image: 800x600, 1024x768, 1280x720, and 1920x1080 (HDTV) matrices are some common DMD sizes. These mirrors can be repositioned rapidly to reflect light either through the lens or on to a heat sink .

An organic light-emitting diode (OLED) is a thin-film light-emitting diode(LED) in which the emissive layer is an organic compound OLED technology is intended primarily as picture elements in practical display devices. These devices promise to be much less costly to fabricate than traditional LCD displays. When the emissive electroluminescent layer is polymeric, varying amounts of OLEDs can be deposited in rows and columns on a screen using simple "printing" methods to create a graphical color display, for use as computer displays, portable system screens, and in advertising and information board applications. OLED may also be used in lighting devices. OLEDs are available as distributed sources while the inorganic LEDs are point sources of light.